Craft Town Hobby Land USA Brand New Easy Cut Punches

all-in-one, allDeco Punch

Instructions for CIRCLE Punch or SQUARE Punch :

1. Rotate lower plate to the CENTER and align each corner line A and B. (as shown in drawing 1).
2. Place the paper on the lower plate.
3. Place upper plate on the paper lightly and align ARROW with C and allow the magnets to lock. (drawing 2).
4. Readjust the paper position gently as needed.
5. After the 1st punch, turn the plate 90˚to the right or left until you hear a click.
    Make sure the ARROWS align and then make your 2nd punch. (drawing 3).
    Repeat the same movements 2 more times to get the completed pattern
    There should be a total 4 punches. (drawing 4).

Instructions for CORNER punch :

1. Position the paper into the CORNER lines
(2 different sizes) and punch (drawing 5).

Instructions for BORDER punch :

1. Rotate the lower plate 90 to the left (drawing 6).
2. Insert the PRINTED DESIGN GUIDER into the left or right of the lower plate base and move the paper to the right
or left the punched design is aligned with the PRINTED DESIGN GUIDER which is included in a plastic case.

Instructions for Design Cartridge :

1. Insert the design cartridge into each plate at about a 45˚ until it is locked.
2. To remove the design cartridge from each plate, lift them at about a 45˚ by pushing the button (see the drawings)

4-in-1, allDeco Punch

Instructions for 4-in-1 CORNER Punch :

1. There are 4 corner positions.
Insert the paper into the desired position (as shown in drawing 1).

Instructions for 4-in-1 BORDER and CORNER Punch :

1. Insert the PRINTED DESIGN GUIDER into the left or right of the lower plate base and move the paper to the right or left
until the punched design is aligned with the PRINTED DESIGN GUIDER which is included in a plastic case (drawing 2).

Instructions for Design Cartridge :

1. Insert the design cartridge into the upper plate vertically until it is locked.
2. Insert design cartridge into the lower plate at about a 45˚ until it is locked.
3. To remove the design cartridge from the upper plate, lift it vertically by pushing the button.
4. To remove the design cartridge from the lower plate, Pull it at about a 45˚ by pushing the button. See the drawing.

IMPORTANT

Because of elaborate cutting designs and sizes,
it is essential to press with two hands.
When pressing the lever with two hands,
apply powerful pressure mainly on the upside

of rubber-made area
of the lever toward
the hinge as drawing 1.

Tips & Tricks

1. To ensure a crip embossing effect, hold and press the punch lever firmly.
2. To remove the upper plate and the lower plate smoothly, it is recommended to slide them, rather than lift them.